This time, we'll show you how to install an "antenna garnish" to dress up your shark fin antenna.
Vehicle used: CX-5
Product details can be found below.
[Antenna Garnish Product Page]
Estimated installation time:0.3h
Difficulty: ★☆☆☆☆
- To enhance the adhesive strength of the double-sided tape, the work environment15℃Please proceed under the above conditions. Also,15℃If you are installing as described below, use a hairdryer or similar device.40Please warm it to approximately ℃ before proceeding with the work.
• The adhesive strength will decrease if the product is peeled off after being applied, so please do not peel it off after it has been pressed down.
After pasting,twenty fourPlease do not wash your car or drive in the rain within the specified time.
Parts cleaner
Degreasing cloth(paper rags or cloth rags)
Clean and degrease the antenna garnish mounting area with parts cleaner.
Peel off only the center of the release paper, and temporarily attach the outer edge of the release paper to the antenna's character line.
②Install the antenna garnish.
Peel off the release paper from the top and press down slowly from the center outwards, conforming to the shape.
Perform the same procedure on the lower side.
Repeat the same process on the other side, and the job is complete!
Finally, check that there are no gaps at the end of the product.
If lifting occurs, press it down again with a soft cloth or similar material.
Mechanical carbon pattern andAutoExeThe logo will give it a sharp and sophisticated look!
Please consider it.