This time, we'll show you how to install the "Shift Knob (MT)," which is now available in three colors with the addition of black and light gray stitching.
Vehicle used: Mazda Roadster (ND)
Product details and compatible vehicle models can be found below.
[Shift knob (MT) product page]
Estimated installation time: 0.1 hours
Difficulty: ★☆☆☆☆
Purchase your shift knob here >>>
■Items required for installation
No equipment is required for installation.
■Installation Procedure
① Remove the original shift knob.
Remove the original shift knob that is currently installed.
*Vibrations from the transmission and the way you operate the shift lever may cause the threads to loosen during use. In such cases, apply a small amount of commercially available threadlocker before installation.
Attach the height adjuster to the shift lever, and then adjust the shift knob to your desired height using the height adjuster.
*When adjusting the height of the shift knob, be sure to ensure that there is at least 10 mm of thread engagement to prevent the shift knob from falling off.
Rotate the locking ring on the height adjuster to securely fasten the shift knob.
The position of the shift knob affects its feel. A lower position results in a shorter stroke but a heavier feel, while a higher position results in a longer stroke but a lighter feel due to the lever principle. Adjust the position to your preference.
Attach the corresponding shift pattern sticker to the vehicle in a location where the driver can easily see it.
*If the shift pattern sticker is not applied, the vehicle will not comply with safety standards, so please be sure to apply it.
That completes the task!
In this video, we used the ball shape, but we also have the stick shape available in the same three colors!
Please choose according to your preference.
