The fin design is inspired by the flow of wind, and the carbon-like design gives it a strong presence.AWe will show you how to install the pillar garnish.
・Vehicle used: MAZDA3
For more information on the product, please see below.
[MAZDA3Vehicle-specific product information:
Installation time estimate:0.5h
Difficulty: ★★☆☆☆
・When applying the pack primer, if it goes beyond the designated area or gets applied to a place other than the designated area, wipe it off immediately.
After applying the pack primer, leave it at room temperature.10Let it dry for a few minutes before proceeding to the next step.
・In order to increase the adhesive strength of the double-sided tape, the working environment15℃Please perform the above procedure.15℃When installing as described below, please use a hair dryer or heat gun to warm up the double-sided tape before proceeding.
- If you remove the product after it has been applied, the adhesive strength will decrease, so do not remove it after pressing.
After pasting,twenty fourDo not wash the car within this time.
・This article applies to the passenger side only.Do the same on the driver's side.
■ Components
・Parts cleaner
・Degreasing cloth(Paper and cloth rags)
・Making tape or packing tape
・Masking tape
*If your vehicle is equipped with Autoexe sports side visors, there is no need to install the small pillar garnish.
"APillar Garnish Large → SmallNo.Press it against the vehicle garnish and slide it.
After that, adjust the position so that the end of the garnish on the vehicle side (circled in blue) is hidden by the "large pillar garnish", and temporarily secure it in place with masking tape.
②Determine the mounting location.
Apply masking tape to the vehicle side to determine the right-hand side installation position, then remove the A-pillar garnish.
Clean and degrease the areas on the vehicle where the double-sided tape will be attached using a parts cleaner.
Apply pack primer to the degreased area and leave at room temperature10Let dry for about a minute.
③Install the A-pillar garnish.
Remove the double-sided tape release paper from the back of the A-pillar garnish large and small from the edge.30mmPeel it off. Fold the tape back onto the front surface and temporarily secure it with masking tape.
Align the A-pillar garnish with the positioning masking tape, press it firmly to prevent it from shifting position, then peel off the release paper from the double-sided tape in the order shown in the video and press it down.
Finally, remove all the masking tape used for positioning.
Perform the same procedure on the driver's side and the work is complete!
The A-pillar garnish features eye-catching fins that resemble the flow of wind and carbon-like materials.
By combining it with the door mirror covers released at the same time, you can achieve a more refined styling.
Please consider it.