This time, we'll show you how to install our new product, the "Center Console Lid."
This product features internal cushioning for enhanced comfort and consistent stitching that harmonizes with the interior.
Vehicle used: Roadster(ND5RE)
Product details can be found below.
[Center Console Lid Product Page]
Estimated installation time:0.4h
Difficulty: ★★★☆☆
Phillips screwdriver
・17mm wrench (only when using an AutoExe shift knob for manual transmission vehicles)
Remove the shift knob and then remove the shift change panel.
*The video shows the removal of an AutoExe shift knob for manual transmission vehicles. A wrench is not required for the original manual transmission shift knob. Also, for automatic transmission vehicles, the removal method is...HerePlease refer to the following.
Open the console lid.
Remove the parking brake panel and disconnect the connector.
*Disconnecting the connector is only necessary for vehicles equipped with a drive selection switch or a commander switch.
The parking brake boot is being secured.2Remove the hooks.
Tapping screw located at the front of the center console(2Book)Remove it using a Phillips head screwdriver, and then remove the center console itself.
②Install the center console lid.
Remove the two screws on the back of the console unit.
Open the console lid.Remove the two screws and then remove the console lid.
We will replace the console lid.
Simply reinstall the console in the reverse order of removal, and you're done!What did you think?
It improves comfort during gear shifting and, by matching the stitching color in the interior, creates a sense of unity as if it were "originally installed."
Please consider it.