This time, we will introduce how to install the "antenna garnish" that dresses up your shark fin antenna.
・Vehicle used: CX-5
For more information on the product, please see below.
[Antenna garnish product page]
Installation time estimate:0.3h
Difficulty: ★☆☆☆☆
・In order to increase the adhesive strength of the double-sided tape, the working environment15℃Please perform the above procedure.15℃When installing as follows, use a hair dryer etc.40Heat to about ℃ before carrying out the work.
- If you remove the product after it has been applied, the adhesive strength will decrease, so do not remove it after pressing.
After pasting,twenty fourPlease do not wash your car or drive in the rain within this time.
・Parts cleaner
・Degreasing cloth(Paper and cloth rags)
Clean and degrease the antenna garnish mounting area with parts cleaner.
Peel off only the center of the release paper and temporarily attach it so that the outer line of the release paper aligns with the character line of the antenna.
②Install the antenna garnish.
Peel off the top release paper and slowly press from the center outwards to conform to the shape.
Do the same on the bottom side.
Do the same on the other side and you're done!
Finally, check that there are no floating ends of the product.
If any loosening occurs, press it again with a soft cloth or similar.
Mechanical carbon patternAutoExeThe logo gives it a bold impression!
Please consider it.