This time, we'll show you how to replace the "battery clamp," which adds a playful touch to your engine bay with its design that mimics a strut tower bar.
Vehicle used: CX-30
Product details can be found below.
[Battery Clamp Product Page]
[Installation Instructions Download Page]
Estimated installation time: 0.1 hours
Difficulty: ★☆☆☆☆
・Gloves or other hand protection
• Deep socket wrench (10mm)
- Extension bar (not essential, but attaching it to a deep socket wrench makes the job easier)
Ratchet wrench
Hex wrench
*The video demonstrates the use of the extension bar.
■Installation Procedure
① Remove the original battery clamp.
Loosen the nuts on both ends of the original battery clamp using a ratchet wrench and a deep socket wrench.
Next, remove the nut using only a socket wrench, and then remove the original clamp.
*The removed nuts will be reused. Please be careful not to drop or lose them in the engine compartment.
② Install the AutoExe battery clamp.
Install the battery clamp in the reverse order of how you removed it.
AutoExePlace the battery clamp against the vehicle mounting point and attach the nuts on both sides.
*This procedure is not necessary for the MAZDA2, CX-5, and Roadster (ND) models, as they have a one-piece structure with no adjustment points.
That completes the task!
Installing it together with a strut tower bar will result in a more unified and coordinated finish.
