Sporty with carbon look! "Rear side spoiler garnish"

---

■ Precautions during operation
- For vehicles with a body coating, remove the double-sided tape from the application area using paint polishing compound.
- If the pack primer spills outside the designated area when applying it - If it gets on areas other than the designated area
If it happens, wipe it off immediately.
After applying the pack primer, allow it to dry at room temperature for about 10 minutes before proceeding to the next step.
• To enhance the adhesive strength of the double-sided tape, please perform the installation in an environment of 15°C or higher. If installing in temperatures below 15°C, please warm the double-sided tape using a hairdryer or heat gun before proceeding.
• The adhesive strength will decrease if the product is peeled off after being attached, so please do not peel it off after it has been pressed down.
Do not wash your car within 24 hours of applying the sticker.
• This article describes the procedure for the passenger side only. Please perform the same procedure on the driver's side.

■Items required for installation

①Determine the mounting position.

The product is temporarily placed on the vehicle, and the cornersA→In the order of BDetermine the position.
At corner A, adjust the position so that the end of the rear side spoiler garnish aligns with the end of the side spoiler R.
At corner B, press the rear side spoiler garnish against the side spoiler in the direction of the arrow, and adjust it to a position where it does not interfere with the liftgate garnish.

Finally, please confirm that the rear side spoiler garnish and the end of the side spoiler at points C and D are parallel. *If they are not parallel, readjust them by moving them from point A until they are in the correct position.

Once the mounting position is determined, secure it with masking tape.

Apply masking tape to the edge of the rear side spoiler garnish as a guide to mark the position. After marking, remove the rear side spoiler garnish.

② Prepare for installation.
Check the position of the double-sided tape on the back of the rear side spoiler garnish, and clean and degrease the area on the vehicle where the double-sided tape is attached using a degreasing cloth.

Apply pack primer to the degreased area and leave at room temperature.10Let it dry for about 1 minute.

While it's drying, remove the release paper from the double-sided tape on the back of the rear side spoiler garnish.30Peel off about a millimeter, fold it back to the front side, and secure it with masking tape.4(Keko)

③ Attach the rear side spoiler garnish.
Work while checking the markings.1Similarly, align the rear side spoiler garnish, and firmly press the adhesive surface while pulling out the release paper in the direction and order of the arrows in the image to ensure that the determined position does not shift.