This time, we'll show you how to install a "carbon seat back bar bezel" made from dry carbon, the same material used in racing cars.
Vehicle used: Roadster(ND5RE)
Product details can be found below.
[Product Information for Mazda Roadster (ND) by Model]
Estimated installation time:0.3h
Difficulty: ★☆☆☆☆
Parts cleaner
Degreasing cloth(paper rags or cloth rags)
Remove the aero board located between the driver's seat and the passenger seat.
Check the placement of the double-sided tape on the carbon seat back bar bezel, and then clean and degrease the surface on the original seat back bar where the double-sided tape will be applied.
Remove the release paper from the double-sided tape on the back by approximately10Peel it off by about a millimeter and fold it over to the outside.
Temporarily place the carbon seat back bar bezel on the genuine seat back bar and adjust its position.
②Install the carbon seat back bar bezel.
While firmly holding the carbon seat back bar bezel in place to prevent it from moving, peel off the release paper from the center outwards.
After peeling it off, press down on the double-sided tape to firmly secure it in place.
The texture of the dry carbon fiber and the three-dimensional AutoExe logo help to differentiate the car when the top is down.
Please consider it.