This time, we will introduce how to install the "shift knob (electric shift)", which has an attractive anodized aluminum texture.
・Vehicle used: CX-60
For more information on the product, please see below.
[Shift knob (electric shift) product page]
Estimated installation time: 0.2 hours
Difficulty: ★★★☆☆
①Upper ball②Sliding base
③Lower ball
④Return spring
⑤Slider
⑥Hexagonal wrench
⑦ Cap bolt
⑧Dowel pin
⑨Set screw
*In order to make the procedure easier to understand, the shift knob is removed during the procedure. Please leave the shift knob installed during the actual procedure.
Apply tape to the flathead screwdriver to prevent scratching the parts.
Remove the cover and spring by pushing them down, then remove the genuine shift knob. The removed genuine parts will not be used, so please store them separately.
Assemble the slider ⑤ into the select lever, and tighten the set screws ⑨ evenly on both sides with the included hex wrench ⑥ until the tips of the set screws touch the recesses in the select lever.
*To prevent the set screw from loosening during use, we recommend applying a small amount of commercially available thread locking material (medium strength).
Assemble the ② sliding base and ③ lower ball into the slider in that order.
When installing the sliding base, align it so that the alignment marks are as shown in the image.
Install the ⑧ dowel pin into the sliding base.
Install the return spring (④) into the slider.
Finally, fit the upper bowl into the sliding base so that the notch in the upper bowl fits over the dowel pin (so that the AutoExe logo faces forward), then tighten the cap bolt (⑦).
Check that it works properly and you're done!
This shift knob has an attractive mechanical texture made from anodized aluminum and a smart silhouette that does not have an unlock button.
Please consider it.