This time, we'll show you how to install the "Carbon Interior Panel Set".
There are four types of carbon interior panels: one for the shift panel, one for the door switch panel, one for the left and right air vents, and one for the center air vent (Roadster only). However, the installation procedure is the same for all of them.
This time, we will explain using the door switch panel on the passenger side.
Vehicle used: Mazda Roadster (ND)
Product details and compatible vehicle models can be found below.
[Carbon Interior Panel Set Product Page]
Estimated installation time:0.2h~
Difficulty: ★★☆☆☆
Degreasing agent
Pack Primer
• Vinyl gloves
■Installation Procedure
① Preparation for installation
To prevent stains when applying the primer and scratches during installation, apply masking tape around the installation area.
Use the included degreasing agent to thoroughly wipe away any oil or dirt from the installation area.
Apply the included pack primer to the bonding area.
*Please be careful not to let the product spill over into areas other than the installation location. It may leave white stains. If it spills over, wipe it off immediately with a soft cloth.
Peel off the backing paper from the carbon interior panel in sections of a few centimeters.
Place the carbon interior panel over the mounting area, and while holding it down, pull out the release paper.
The Roadster version features a matte finish with a non-glossy clear coat, while the SUV version boasts a glossy finish for a sophisticated look, each perfectly matching the respective vehicle's interior.
You can also order individual cuts of meat, so you can choose according to your preferences.
Please consider it.