This time, we will introduce how to install a "carbon seat back bar bezel" made of dry carbon, which is used in racing cars, etc.
・Vehicle used: Roadster(ND5RE)
For more information on the product, please see below.
[Product information for Roadster (ND) models]
Installation time estimate:0.3h
Difficulty: ★☆☆☆☆
・Parts cleaner
・Degreasing cloth(Paper and cloth rags)
Remove the aero board between the driver's seat and the passenger seat.
Check the position of the double-sided tape on the carbon seat back bar bezel, and clean and degrease the double-sided tape attachment surface of the genuine seat back bar.
Remove the release paper from the double-sided tape on the back side.10Peel it off about a mm and fold it back on the outside.
Temporarily place the carbon seat back bar bezel on the original seat back bar and align it.
②Install the carbon seat back bar bezel.
While holding the carbon seat back bar bezel firmly so that it does not move, peel off the release paper from the center to the outside.
After removing it, press the double-sided tape part firmly to make sure it is firmly attached.
The dry carbon texture and the AutoExe three-dimensional logo help differentiate the car when it is opened.
Please consider it.