立体感溢れるクロームメッキ!「フューエルリッドカバー」

This time, we will introduce how to install a "fuel lid cover" that adds a mechanical impression to the fuel filler opening.

Vehicle used: MAZDA3

For product details and compatible vehicle models, please see below.

[Fuel lid cover product page

Estimated installation time: 0.3 hours or more
[Installation instructions download page

Difficulty: ★☆☆☆☆


■Things required for installation
- Parts cleaner (removes dirt and oil from mounting parts)
・Paper towels (cloth towels are also acceptable)
・Masking tape

■ Installation procedure

① Paste the pattern

*This process is not necessary for the Roadster (ND) as no pattern is used.

Cut the paper pattern along the cutting lines.


Place the template on the side panel, aligning it with the rear door edge, fender arch, and fuel lid edge, and attach it with masking tape.


② Fuel lid cover installation

Determine the position where you will attach the fuel lid cover and temporarily secure it in place with masking tape.
When doing this, make sure that the edges of the fuel lid cover and the fuel lid overlap evenly and that the protrusions of the fuel lid cover are aligned on the extension of the dotted line on the template.

Flip the fuel lid cover over and degrease the surface where the double-sided tape is attached (the outer periphery of the fuel lid). Do not spray the parts cleaner directly onto the mounting area, but spray it onto a paper towel or similar before using.


Apply pack primer to the double-sided tape attachment surface of the fuel lid and allow it to dry. (10minutes)

Peel off the backing from the double-sided tape, fold it back about 30 mm to the front and secure it with masking tape.


Carefully check the position, pull out the backing of the double-sided tape, and then firmly press the fuel lid and fuel lid cover together.

Remove the pattern and masking tape and your work is done!


Although there are slight differences depending on the vehicle model, the basic installation method is the same.
We recommend combining it with the "fuel cap cover" that is attached by placing it over the fuel cap.


"Fuel Cap Cover"DIYpageWe have also created this, so please consider it as well.